APF9328

Description

The APF9328 is a reduced size processor board benefiting from a highly competitive price/performance ratio.

Fitted with an ARM9 200MHz processor, SDRAM, FLASH, a 10/100Mbits Ethernet port and a (200K gate) Spartan 3 FPGA , it is easily integrated into an embedded system thanks notably to its regulators and level converters (RS232/USB).

Note : no external debugger (BDI, JTAG) is required. A simple RS232 connection is enough for "low-cost" development. A Linux debugger is available (GDB).

Processor

MC9328L(i.MXL) ARM920T 200MHz (Freescale)

RAM

8/16 Mo 32bits @ 100MHz

Flash

4/8/16 Mo 16bits @ 100MHz

Peripherals

1 x RS232 (RX/TX)
1 x RS232 TTL levels (RX, TX, CTS, RTS)
1 x I2C
2 x SPI
1 x SSI (High speed synchronous serial port)
1 x USB 1.1 slave only with level converter
1 x Ethernet 10/100 Mbits (no RJ45 connector)
1 x SD/MMC
1 x RTC (no battery)
1 x PWM 16bits resolution
2 x Timer 32 bits with input capture/output compare
1 x Watchdog. Adjustable timeout between 0.5s and 64s (0.5s step)
LCD controller up to 640x512 (64K colors)
CSI (CMOS sensor interface)
97 total I/O pins multiplexed with most dedicated functions for pin efficiency (GPIO)
JTAG (Debug (ICE) and test)

Ethernet

10/100Mbits (can be removed on demand)

DAC

2 channels 10bits 400kHz (can be removed on demand)

ADC

8 channels 10bits 10MHz with internal fifo (can be removed on demand)

FPGA

Xilinx Spartan3 with 200k gates (50k FPGA or 400k FPGA optional)

Power supply

+3.3V supply 5%. typical power consumption: 300mW (without the FPGA)
Two power saving modes

Environment

Cooling : None for temperature below 60°C*.
Operating temperature range: 0..60°C * (without cooling)
Storage temperature range: -10..70°C
Humidity 5-90%

* FPGA not taken into account. Depending on IP used, cooling can be required and max temperature can be decreased.